404 - Not Found

We're sorry, the page you were looking for was not found.

Please check out one of our links above or use the sitemap to direct you.


Article of the Week

From The Setpoint Blog

Tie-Rod Frame v. C-Frame

In the past, the C-frame press design made it easier to feed in product or change dies. The downside of the C-frame is deflection - where the frame will bend outward under the pressure of the load - which will cause deformities in you part, and ultimately lead to inconsistent and erroneous parts. In our brass case manufacturing equipment we need absolute precision and a lot of force. So we needed a better solution.

Read more on our blog

Let’s Talk Now 866-532-6856

Or fill out the form below and we will contact you.